IndianaPaul
Silver Member
Have read through the posts on Boxblades and TNT and find myself still looking for advice/thoughts on the matter. I run a NH TC45D, no TNT. Find myself looking for a good boxblade, preferably 6-7' scarifers/blades. Will be used for driveway maintenance and levelling out about 14 acres of former livestock pasture (lots and lots of low spots, fairly level to begin with though) and any other projects which may arise.
My questions:
1) Am I right in thinking more weight is good when it comes to boxblades? I've looked at Wallace (at least I think that is who makes them for Rural King) and they seem a bit on the light side, also have looked at KingKutter at TSC and they seem a bit light of weight as well, though heavier than the ones at Rural Kings. Will also be looking at BH and LandPride in next couple of weeks. Am I missing any others I should consider?
Any other suggestions? Good or bad experiences with the brands?
2) I did not get TNT when I purchased my NH, am leaning towards having it installed next time I take unit in (probably this fall). If I don't go with TNT, does make it much harder to use the boxblade effectively?
3) Is a 7' boxblade too much for the TC45? Width with tires dished in is a smidge over 61", so a 6' blade would work as well.
Any thoughts would be greatly appreciated.
IndianaPaul
My questions:
1) Am I right in thinking more weight is good when it comes to boxblades? I've looked at Wallace (at least I think that is who makes them for Rural King) and they seem a bit on the light side, also have looked at KingKutter at TSC and they seem a bit light of weight as well, though heavier than the ones at Rural Kings. Will also be looking at BH and LandPride in next couple of weeks. Am I missing any others I should consider?
Any other suggestions? Good or bad experiences with the brands?
2) I did not get TNT when I purchased my NH, am leaning towards having it installed next time I take unit in (probably this fall). If I don't go with TNT, does make it much harder to use the boxblade effectively?
3) Is a 7' boxblade too much for the TC45? Width with tires dished in is a smidge over 61", so a 6' blade would work as well.
Any thoughts would be greatly appreciated.
IndianaPaul