MFIndustrial20
New member
I have a 1975 Massey Ferguson Industrial 20 (similar to 135).
Today I was trying to rebuild one of the power steering cylinder assemblies, and for the life of me I cant pull the end-assembly off of the shaft to remove/replace the seals (which I have already picked out). I've already knocked out the pin, so it should come off. It's probably been on since the tractor was built in '75. What am I doing wrong? Do I need special tools? Should I get out the MAP-gas torch to heat it up?
:confused3:
Today I was trying to rebuild one of the power steering cylinder assemblies, and for the life of me I cant pull the end-assembly off of the shaft to remove/replace the seals (which I have already picked out). I've already knocked out the pin, so it should come off. It's probably been on since the tractor was built in '75. What am I doing wrong? Do I need special tools? Should I get out the MAP-gas torch to heat it up?
:confused3: