willierides
New member
I am a new member here. I recently bought an Iseki/Bolens G174 four wheel drive with a bucket and finish mower. It had flat rear tire when I bought it. I removed the pin and can not get the hub to budge either by pulling (with a GOOD puller) or by twisting it (in case it's threaded on there). It looks like the hubs can be mounted two ways, with the rims inside the flange or outside the flange. Mine are mounted with the flange on the outside, so the hub must be removed to get the rim off.
Can someone tell me 1) how the hub is held on there once the pin is removed? and, 2) where can I find a reputable source for a good service/repair manual?
I posted this in the parts and repair forum. I think that was a mistake and apologize now for "cross posting". I'll be more careful in the future. Thanks!
Can someone tell me 1) how the hub is held on there once the pin is removed? and, 2) where can I find a reputable source for a good service/repair manual?
I posted this in the parts and repair forum. I think that was a mistake and apologize now for "cross posting". I'll be more careful in the future. Thanks!