The final figures work out to be 20000lbs dump force to a 48.5* angle.
It is a bit more force than I had in mind when I was first sketching but once the fabbing started I was able to get the pivots in better locations than I anticipated resulting in about 3x's the force I really need. Which isn't a bad thing because the pump will only develop enough force to do the work, which will be about 1000psi. So I shouldn't have to worry about blowing any hoses anytime soon.
I also forgot to add that the pump runs about 4.8gpm @ 3000psi, which is 2000 truck rpm. It takes 16 sec to full raise but about 2 min to come down, due to not being a power down(which I may change because the DCV has a port for that that I just blocked) so All I would need is about another 25 ft of hoses and fittings.
The Hyd resivoir is a 3 gal that I put 2.5 gal in ( my tractor takes 7.5 gal so it works out perfect fo 2 buckets)
The pump is ran off the AC clutch so it doesn't run but only to dump so I only need enough fluid to fill the cyls.
Heres some pics of my figures if any of you other math/hydraulic fellows want to check my #'s The flash got me in the first pic they are 2.5" x 30" cylinders