Skaggydog
New member
Troy Bilt Horse 4 forward 2 reverse. I removed 7hp Briggs and installed 212cc
Predator, the $99 Harbor Freight special that starts right up. The Briggs had
3/8 X 1 1/2 hex bolt in end of shaft holding reverse on with only a lock washer,
no spacers. I used 5/6 X 1 1/2 in the Predator. When I tightened the bolt the
pulleys slid about 3/8" or 1/2" in front of lining up with bottom pulleys.
Where should I put a spacer and what kind of spacer should it be?
Thank You
Predator, the $99 Harbor Freight special that starts right up. The Briggs had
3/8 X 1 1/2 hex bolt in end of shaft holding reverse on with only a lock washer,
no spacers. I used 5/6 X 1 1/2 in the Predator. When I tightened the bolt the
pulleys slid about 3/8" or 1/2" in front of lining up with bottom pulleys.
Where should I put a spacer and what kind of spacer should it be?
Thank You