Search:

Type: Posts; User: k0ua; Keyword(s):

Results 1 to 8 of 8

Search: Search took 0.19 seconds.

  1. Replies
    63
    Views
    12,489

    Re: Yet another bucket-mod thread

    Coolness:thumbsup:
  2. Replies
    63
    Views
    12,489

    Re: Yet another bucket-mod thread

    Joshua, you have probably seen this before, but it is well worth watching again. It deals with tackups and "pulling" and how to overcome it.

    ARc Welding Project -Everlast PowerPro 256 - YouTube
    ...
  3. Replies
    63
    Views
    12,489

    Re: Yet another bucket-mod thread

    Joshua, your welding is getting better and better.. Keep at it.. I am just a Half-"fast" welder myself, at best, on a good day.:)

    James K0UA
  4. Replies
    63
    Views
    12,489

    Re: Yet another bucket-mod thread

    If it was me, I would take that 1/8 rod and go over some of those welds on the back side. Clean them up first real well with a brush on your angle grinder, and hit another pass on the weld and a...
  5. Replies
    63
    Views
    12,489

    Re: Yet another bucket-mod thread

    I didn't on mine, I figured the welding would burn the paint anyway.

    James K0UA
  6. Replies
    63
    Views
    12,489

    Re: Yet another bucket-mod thread

    [/COLOR]

    It will do you good to do this, and look good and you will be proud of it when it is done.. just measure and mark carefully and use your angle grinder with a "slitter" disk to cut the...
  7. Replies
    63
    Views
    12,489

    Re: Yet another bucket-mod thread

    Mostly I think it will look better, to cut out slots for the vertical uprights, and weld to them.. Just how I would do it.. as far as painting, it is just rattle canned. the Kubota with TSC Valspar...
  8. Replies
    63
    Views
    12,489

    Re: Yet another bucket-mod thread

    Josh, I went ahead and welded the whole top with 1/4 inch on my old Kubota bucket, to reinforce it. I think you can handle this project at this point. I stitch welded it at first, but decided I did...
Results 1 to 8 of 8
© 2017 TractorByNet.com. TractorByNet is a registered trademark of IMC Digital Universe, Inc. Other trademarks on this page are the property of their respective owners.