Search:

Type: Posts; User: fuel doctor; Keyword(s):

Results 1 to 21 of 22

Search: Search took 0.00 seconds.

  1. Replies
    6
    Views
    247

    I have a 750 I think it is 3 more h.p then yours...

    I have a 750 I think it is 3 more h.p then yours it pulls it fine . I had to add weight to the front
  2. Replies
    4
    Views
    365

    The water more then likely is getting in around...

    The water more then likely is getting in around the rubber boots on the shifters . The right brake is that brake pad has not come all the way off so you have high and low spots on the disk making the...
  3. Replies
    3
    Views
    493

    Yes it may be . Sometimes we overlook the basics...

    Yes it may be . Sometimes we overlook the basics . Maybe that is what it is.
  4. Replies
    3
    Views
    493

    Do you have to add antifreeze often . If so you...

    Do you have to add antifreeze often . If so you may have a blown head gasket . That will cause alot of pressure in the rad. It will blow out the coolant
  5. Replies
    4
    Views
    274

    On some if the valve you can take it apart. There...

    On some if the valve you can take it apart. There is a o-ring that does the sealing. Sometimes dirt will get in the seat and not let It seal when you close the valve. It wouldn't hurt to open & close...
  6. It could be a pressure switch that is not letting...

    It could be a pressure switch that is not letting power threw. on the blower there is a resistor that goes bad and want let it blow on high
  7. Replies
    1
    Views
    140

    It has 3 wires red white black .red should have...

    It has 3 wires red white black .red should have power with switch on .white wire has power on it when you go to start the engine is the only time it has power on it. It is what pulls the sol in red...
  8. Replies
    13
    Views
    2,835

    There is a switch along the relays the best I...

    There is a switch along the relays the best I remember it is a switch that when you bounce up & down on the seat on rough ground it keep the mower going. But if you remain up for more then a second...
  9. Replies
    20
    Views
    1,049

    It sounds like glow plug controller.they should...

    It sounds like glow plug controller.they should not cycle after the engine is up to temp
  10. Replies
    20
    Views
    1,049

    Check your wires to make sure they are not in bad...

    Check your wires to make sure they are not in bad shape and ground . The glow plugs stay on for a little bit after the light goes out to help control smoke on a cold engine. E.P.A requirement for...
  11. Replies
    20
    Views
    1,049

    There is a glow plug relay sometimes called glow...

    There is a glow plug relay sometimes called glow plug timer . It is under the dash it is like a little box . The reason the light doesn't come on all the time after you start it or cycle the switch...
  12. Replies
    2
    Views
    289

    Yep that is normal . Nothing to worry about

    Yep that is normal . Nothing to worry about
  13. Replies
    10
    Views
    781

    There are I think 4 balls in the actuator that...

    There are I think 4 balls in the actuator that will get rusted up and make it hard for the brakes to work. As far as the seal you will destroy the bearing trying to get the bearing off to replace the...
  14. Replies
    1
    Views
    351

    I would soak it with some lube of some kind and...

    I would soak it with some lube of some kind and let it set for few hours . And then put some heat on it just keep working it . Lube & heat I think it will break free.
  15. Replies
    13
    Views
    1,406

    Most of the time it is dust and hay dust that...

    Most of the time it is dust and hay dust that gets in the vent and the oil just makes it stick in the vent on the cap
  16. Replies
    13
    Views
    1,406

    Yep I would start with the filters there should...

    Yep I would start with the filters there should be 2 one at right side rear axle the other on the transmission. On most there is a washout screen in the transmission. You might already no you need to...
  17. Replies
    13
    Views
    1,406

    Well glad I could help. Your cap look pretty...

    Well glad I could help. Your cap look pretty stopped up.
  18. Replies
    2
    Views
    346

    Does it have fel.if not there is a relief valve...

    Does it have fel.if not there is a relief valve on the cylinder block that will get stuck or a blown o-ring where the lift top sits down the best i remember it has been a while sense worked on one ....
  19. Replies
    13
    Views
    1,406

    What size and what kind of tractor.I should of...

    What size and what kind of tractor.I should of asked.because some have a vent tube on transmission that I have seen bugs stop up the vent.on some of j.d tractor the vent is made in the cap . If you...
  20. Replies
    13
    Views
    1,406

    Stopped up vent . Depending on what size tractor...

    Stopped up vent . Depending on what size tractor some of the vents are on the cap where you put the fluid in
  21. Replies
    3
    Views
    325

    On alot of them there is a hold relay that may be...

    On alot of them there is a hold relay that may be getting weak . it is just like a regular relay
Results 1 to 21 of 22
© 2014 TractorByNet.com. TractorByNet is a registered trademark of IMC Digital Universe, Inc. Other trademarks on this page are the property of their respective owners.