Search results

OK I'm cheap . I used up a 5gal bucket of Hydraulic fluid and waited till I had problems before I bought a new one.The front loader and three point were slow then the steering started to get hard .I put the Jinma 254 away and got some fluid and filled it up .Now I have no pressure.I checked the...

I'm looking for bolts , blades and blade adapters for a Jinma Finish mower . Its the five foot one. thanks Ray Kevis

Jinma 254 FEL Chipper I ran the chipper for a couple of hours and when I tried to return to the garage the 3 point would barely lift the unit . I let it sit for a while and it was fine. Is this normal hot hydraulic fluid? Anyone?

Well I've got 81 hours on it and have been watching the temp and oil pressure like a hawk.This is the machine that I replaced the rod bearings in after my crew ran it out of oil. Its been running fine but the oil leak is getting out of hand and its time to fix the rear seal.How do I go about...

Just changed the oil in my Jinma 254 engine .This is the engine I changed bad rod bearings in. Why does the oil on the dip stick look clean and the oil I drained out look black?Am I not getting circulation? thanks Ray Kevis

I pushed over a small tree and ended up catching the front right tire on a trailing root. The tire was unable to turn because of the root ,the left was still turning. Now I have no four wheel drive . I jacked up the front and I can turn one tire and the other turns the other way and I can turn...

Jimna 254 PTO clutch stuck ,It will engage and disengage with the lever but clutch will not.Suggestions? thanks Ray

I have a Jinma 254 and it won't start .Ran fine for 100 hours. It cranks over very slowly ,battery ,connections and starter are all good . It seems something is binding in the engine.Turns over a little faster when decompression lever is engaged.Can turn over by hand via PTO but hard. Any...