Search results

Will the new cylinders need to be filled with fluid before installation? Or can I install and operate a few times and then top off the main reservoir?

This unit is about 18 months old with 354 hrs. I use bucket, grapple rake and tree puller on the FEL. Recent problem with the joystick cables coming unscrewed at the ball joints were fixed by dealer after 3 tries. I go out today and the loader lifts, lowers, curls but will not roll the quick...

The hydraulis control handle for the loader stays tilted to one side. This just happened today. What could have caused this?

My neighbor gave me this mower yesterday along with a piece of a part that I have identified as part of the variable speed pulley. Check photo. What could cause this to happen? I have the part ordered but don't want to end up with another broken part. Also any tips on how to change out the...

LS XG3032 I am out in the field and noticed a blinking hour glass on the left side of the hour guage. What does it mean?

Traded my 2014 LS J2023H w/ 50" Loader and AG mini grapple for 2016 LS XG3032-4L w/ 60" loader and 60" AG grapple. I loved the J2023H but for the majority of work I do which is pushing over cedar trees and lifting the root balls up out of the ground I need a tractor with a bigger foot print and...

My original thread posted in another forum but may it should be in this forum. http://www.tractorbynet.com/forums/parts-repairs/346683-ls-j2023h-ignition-switch-problem.html#post4268373 The tractor is 6 months into warrenty with less than 80 hours. I recently got it back from the dealer in...

I shut down the tractor this morning and went inside for breakfast. When I came out to start it there was not dash lights nor would the engine turn over. I removed the panel to which the switch is mounted to access the fuses. The fused ok. While the panel off and switch still connected I turned...

I have 60 hours on my new LS2023H and the muffler is cracked just above the manafold mounting flange. It is nearly broken all the way around. The only thing i can figure is the bracket that secures the exhaust pipe is not aligned so that when tightened the setup is torqued so much it creates the...