Search results

I've had this mower for a little over 2 years...I find myself using my Massey Fergurson tractor more....the major problem is the beer holder is on the same side as the discharge chute...I get grass clippings/dust in my beer....on the Massey it's on the opposite side! Don't these CC engineers...

well, I removed the MMM (to do the 50 hr svc) and since it was off I decided to hook up my tiller and till some gardens before putting the MMM on. Did a neighbors (who keeps me fully supplied with squash/zuchinni/scalloped squash/greens) all summer...his garden was about 25x60. did another...

Well, the time is here. I had already changed the oil at 15 hours to remove the break-in oil and now will do the full 50hr service. I put Rotella T 15w-40 in at that time (that's what I run in my truck the other tractor I had). I want to put Amsoil full synthetic 5W-40 in and was wondering if...

As far as Iseki goes, these are really bullet proof. I had a 1981 bolens (Iseki) that never failed and it was run hard......It was stolen otherwise I'd still have it. I now have a MF GC2300 with the Iseki and I love it too!

Been mainly using my GC2300 to keep my lake lot mowed http://www.keltonkrew.com/temp/lakelot-1.jpg Well, the lake is down so I built a pier...there were all kinds of grass that had grown up http://www.keltonkrew.com/temp/pier2.jpg http://www.keltonkrew.com/temp/pier3.jpg Well, this past...

well, after 4 weeks of wondering about a replacement for my stolen tractor, I will be picking up my GC2300 tomorrow. I initially was looking at the Kubota BX2350 but will be getting the MF. I've been on both of them..both seem fine to me. The MF has a little more PTO hp at lower rpm than the...

I was initially looking at the Kubota BX2350 which has a full floating 60" MMM. However I will now be getting a GC2300 (insurance). Is this MMM a ground contact or floating MMM? Also, how do you compare the Kubota BX2350 to the GC2300. I had this same question posted in the Kubota forum and...

My tractor was stolen and Insurance will be covering it. I spec'd out the BX2350 and I think that's what I wanted. Insurance has spec'd out the Massey GC2300 (and it's more expensive). Can anyone tell me which would be a better tractor. I was really wanting the BX2350. thanks

Went to go put some stuff in storage. Pulled up and no lock on my storage unit. Heart sank when I opened the door to find my 8' 2" pipe tilt trailer and my tractor gone! they didn't take the rest of the implements (at least not yet). So now I'm without my trailer and a good diesel tractor...

A friend has a YM-2002 and needs a couple of parts and has been having trouble finding them. I'm hoping someone here can help. 19-4430-25171 double gear 19-4420-27160 range shifter if you know of a place where he can get these, he would sure appreciate it.

I have a 48" BMB rotary mower (cat 1) that I use behind my bolens (Iseki) G174 I need a new bearing assembly/shaft that 1 of the blades bolts to and the belt goes around the pulley. One of mine is bad and I need to find a replacement part. thanks

After doing searches on filters, oil, etc. for my 2005 CC 2042 Here's what I have determined. Please verify if this is correct. oil filter Carquest 85516 (2x longer than oem) Oil - Mobil 1 10wx30 Trans filter Carquest 85410 CC fluid for the rear. I've read to change the oil after the first 5...

I have a 1981 G174 by Bolens (Iseki). When I engage the 4wheel drive, I hear a clunking noise from the center of the gearcase. I speeds up with revolutions and keeps pace with the speed of the wheels. When I take it out of 4wheel drive, no noise. I've been leaving it in 2 wheel drive mode...

New to the forum. I've done some searches but really couldn't answer my questions. I'm in the market to buy a new mower. My yard-man (POS) bit the dust. I still have a cheapy Craftsman 4000 with 42" deck. Kohler engine runs good, but mower doesn't cut well, uneven (probably the bent frame)...