Search results

I need to replace the gauges in my MF35. Is there an easy way to get up in there with out pulling the entire shroud? Or do I need to pull the steering wheel and take the shroud off? Thanks

Ok my right rear tire was low a couple of times so I aired it up and went on my merry way cutting grass. Last week the same thing except my daughter ran out and said the outside of the tire was all wet! Yup leaking fluid from around the stem. Parked the tractor with the valve up to help keep...

I have a 460 utility and I am having lift problems. The other day I was moving some dirt with the loader. After about 8 loads I went into the pile, pushed up on the lever and nothing. Backed out and the list dropped about 8-10 inches. I tried to lift it again and it dropped again and stopped...

have and old stan-hoist front end loader. the cylinders are starting to leak at the ends. any body know where to get rebuild kits or who rebuilds them? thanks

i bought a ih 460 industrial gas with a t/a. looked at it the other day and it tested out fine. brought it home today and played with it some more. put some dirt in the loader, dropped it because i was starting to get stuck in the mud and left in 3rd gear. i drove about 20 yards or so, stopped...

have a g5200 with the 48 inch deck. does anybody know of a good place(cheap) to get a new deck or a good used one? i think my deck has shot craps. the holes in the deck are to large now and the grass packs in so bad its not even funny! i think it also might be some of my overheating problems...

wow, just found this sight... way cool..... i have a g5200 (600 hours) with an over heating problem. its driving me crazy!!!!!!! to say the least. i have had the rad boiled out x2, flushed the block out x 4, new rad cap, thermostat, etc etc etc. i have even brought it to three diff kubota...