Search results

I have a homemade splitter so I guess this is the best place to post my question. I got tired of pulling the rope when my little 5 hp stalled out on my splitter so I added an 18 hp with electric start and vertical shaft, but no mounting holes. At the time I let the pump drop under the mounting...

Hello all. Does anyone have any experience with changing a 231S from vertical to horizontal exhaust? Is a new manifold required? Any idea of the cost involved? Thanks Terry Piedmont, AL

Need your help guys. I don't know what type hubs were used on the homemade axle for my log splitter:confused: . I would like to increase the size to 15 inch from the current 13, but don't now what type wheels will interchange. Does anyone know where I can check bolt patterns to determine the hub...

I just purchased a Ford IOI series plow. It shows the component number as either IO 464 or IO 4b4, can't tell for sure. First, does any one know what I have? Is this the same plow referred to as the 101? This is a 3 bottom plow, looks to be 16s, but I have not measured. Can someone tell me what...

Has anyone heard of an auction that takes place in Chula, Ga this weekend? I'm told it's a charity auction to support the TiftAreaAcademy. Thanks Terry

Ok, I need help from you machinists out there. Several years ago I purchased a package of drill bits that have almost a pilot bit type point. What I mean is the first 1/4 inch or so was smaller that the rest of the bit. These are/were awesome bits and drilled through anything. Problem is, I'm...

My log splitter has a Cessna pump. Does anyone have any information on them? I tried web searches, but not able to get any specs. I can't find the model number on it. What gpm are these pumps? Thanks for looking Tnau

I'm just full of questions and can't seem to find the answers during searches. I want to change all the hydraulic hoses on my log splitter to hard lines, probably steel gas lines. Has anyone seen this done? Will I have a drop in pressure by adding 90 degree elbows into line? Thanks for looking...

Hey shop guys. Need help for a question brought up on the Lawn and Garden forum. I want to add electric start to my splitter so my dear one can help with the firewood. There was an older post that discussed the use of a hydraulic pump on a verticle shaft motor rather than the typical horizontal...

Has anyone had any experience adding an electric starter to a Briggs and Stratton on a log splitter? I want to make this thing wife usable and she says electric start only. The motor is a 5.5hp I took off my tiller. Thanks T

Help! I'm not a CUT owner, yet. I need help with my UT. I have a MF231S and over the weekend the lift started to drift back up. I push the lift down and the lever brings itself back. Anyone seen this before? :confused: Thanks for looking T Naugher Piedmont, AL