Search results

The three point arms rise as soon as the engine is started even with the control set to down.

I have a Landini 70 series Blizzard and I need to change the steering ram seals. I think the end cap should unscrew but there are no flats to use a spanner on - only one little hole. What is it for?

I broke the chain that drives the knotter and feeder with the needles mid position. I have ordered a new repair link, but would like your comments regarding timing. I think the breakage was due to a chain that was very rusted and the crack on the link was half fresh and half old. I am hoping...

I am working on an old JD 219 baler. The knots would not tie, so I started looking for problems. The first think I noticed was the slackness on the stripper arm shaft. I took out the split pin on top and the two washers and pulled the shaft out. The first thing I noticed is that there is a...

The first thing I noticed on a recently acquired baler was the lack of drive to the flywheel. I suppose that the splines on the drive plate are worn through. Is this an easy fix? What is the name of the plate? Anyone know the part number? Humphrey

I have a John Deere 3040 tractor that is losing a lot of oil from a cylindrical tank above the oil cooler and radiator. The previous owner simply put a hose into a drum to collect the oil and reused it. The cylindrical tank has a banjo connection on the top that the oil is coming from. It is...

Can anyone tell me where the serial number plate is located? Humphrey

Hello to all from France. My friend has just bought a farm nearby and found a baler in the weeds. Trouble is that there is no control unit to run it with. Is there any chance of getting one with the connector? Is it possible to make one? The air springs are completely deflated, but I will pump...