Search results

Ok so I have replaced a steel hydraulic line and pulled of the left side axle housing to fix the diff lock and know i can not get the brakes bleed. I have made sure that the seals around the brake disk were not cut when i put that part back together (after i cut the first set putting it...

I am going through and changing the hydraulic fluid and all filters. I have bought the filter screen but can not figure out where it is located. I took of the left side food board and took off one plug but it wasnt it and I cant see any other place where it would go

Ok. So it looks like I have the power steering option. I have one hydraulic line on the bottom of the steering column on the right side.

I took the old girl down the road today and that was a scary ride! I have noticed the there is play in the wheel but man its a lot worse than i had expected. So when i got home i was looking at it and when i turn the steering wheel right the whole steering wheel turns up and that is about 3/4 of...

So I have never used the ether on my tractor. There is a spot to screw on an ether can below the steering wheel. My question is where can I get an ether can that screws on

I have a 1970 JD 400 industrial loader with a backhoe. Let me just say this. I dont know a thing about hydraulics so bear with me because probably somethings that you guys say is probably over my head. At some point someone put a thumb on it with a lever valve that is plumbed in with the curl...

Ok. So i took the starter out and took it to a garage that my wife works at and one of the techs there bench tested it. He said the starter is fine and he be leaves that my problem is the spacer and the tip of the starter is no longer sitting in the grove witch is letting the gear over through...

There was on the old solenoid. So i bought a new one and same problem. I took the ignition switch out and with a multi meter checked from the battery lead on switch to the solenoid lead on switch while the key was in start position and it toned good. When i let go of the key as if it has started...

I have a 1970 JD 400 industrial. A few days ago i tried to start it and it just kept cranking. I pulled the starter took it apart and cleaned it up. To day i put it back in and it did it again so i went out and got a new starter solenoid and put that on. Well guess what... It does the same thing...

Hi all. I have a 1970 JD 400 loader backhoe. I would like to enclose it. Has anyone made a cab for one of these before?

Ok so I just got in from moving the wire to a ground spot. I used the light bracket as that is where the light is grounded to. The needle moved to empty when on a ground spot. So I take it that the gauge is ok and the sending unit is probably junk?

Hi. I am new here. I just got a new to me JD 400. All in all it seems to be a decent machine. I am having trouble with the fuel gauge. It always says full. I found that the wire going to the tank wasn't there so I fixed that. But the gauge still doesn't change it always says full. How do I know...