Search results

Hello everyone, I rebuilt a 95 New Holland 268 engine I now have 50 hours and it's still hazing at idle with unburnt fuel. The book was very vague on timing the pump. What I did was used a dial indicator got the #1 on top dead center lined up all my gears and installed the injector pump with the...

I have a backhoe frontbucket that only has the shanks no teeth. I have all the measurements on the shanks so what is the best way to match the proper tooth for the shank?

Hey guys my first time getting to use the backhoe since I bought it and done a lot of work on it. The hydraulics in the rear or making an awful noise a little slow and jerky as if it has air. I just rebuilt the boom cylinder but all the cylinders are making that noise. I can't figure out what it...

I was wondering if it is possible for a injector pump to over fuel an engine? I have a brand new 95 Ford 268 with 2 hours on it and I put the old pump back on and I'm getting just a little unburnt fuel at idle. It's a Lucas injector pump. I do need to check my injectors and see if they're...

Hi guys I've got a Ford 655d that is new to me. I've been doing a lot of work such as rebuilding the engine Etc but I'm having an issue when you put it in forward or reverse it jerks and starts pulling at low idle. I tested the controller and the voltage slowly goes up to 7 volts but because I...

Hi everyone I need to rebuild my boom cylinder on a 655d there seems to be two different kits one for a HED and one without an HED. I do not know what HED stands for do any of you guys?