Search results

Results 1 to 7 of 7
  1. F

    Oil & Fuel  Fuel Solenoid Problem

    A couple of years ago I bought a new 3300SU. For over a year now the fuel solenoid is not "clicking" when I turn the key. Sometimes it does, and some times it doesn't. I've traced the problem to the little grey plug-in that goes into the side of the solenoid. Jiggle the wires, and eventually...
  2. F

    3300 engages forward HST lever at an idle

    When I stop my 3300 and leave the engine at an idle, I can hear the transmission engage (forward, usually). If I don't set the brakes it'll run off if the ground is level. My question: What do I have worn out and thus, needs replacing to stop this from happening? Is it an adjustment or the...
  3. F

    Mowing  Grass removing seal in transmission

    A year ago I bought a new 3300SU Kubota. Recently I've noticed a drip or two of oil on the shop floor when I parked it. I took it to the dealer and he said that mowing in tall grass will allow grass to wind around the 4-wheel drive shaft out of the transmission and will eat the seal. Who...
  4. F

    B2630 Won't Start

    I have a B2630 HST. This morning the starter wouldn't motor and thus, the tractor won't start. It did this once before and it was a fuse in the fuse box behind the dash. I checked these and replaced one. Still no starter on the key switch. I can jump it across the starter and engage it with...
  5. F

    Tiller  Parts for Agric AL50 Tiller

    Anyone out there have a source of parts and pieces for the Agric AL Series Tillers? I need a chain cover, tensioner, and bearings for mine. Thanks, Fritz
  6. F

    4wd 2150 Front Axle Leak

    Any one have any experience replacing seals/gaskets on the outboard end of the front axles on a tractor of this type? The leak appears to be around the axle itself. Is there a shielded bearing inside? I'm assuming I'll need to open the banjo-shaped cover over the the down drive so I'd need...
  7. F

    FEL Control Valve Re-Build

    I have an LA350 FEL on my 2150 Kubota. The bucket has been getting lazier and lazier over the past year, especially in the "up" mode. I've done the sump screen, the fluid and filter replacement, etc. and that didn't help. I think it's time to re-build the valve. My question: has anyone done...
Top