Results 11 to 20 of 33
-
01-06-2013, 10:10 AM #11Platinum Member
- Join Date
- Jun 2004
- Posts
- 657
- Location
- Armstrong, BC
- Tractor
- Kioti DK35 SE HST (2011)
There's also increased danger of rolling over backwards if dragging such a suspended weight, particularly if going uphill.
-
01-06-2013, 10:13 AM #12Elite Member
- Join Date
- Jan 2009
- Posts
- 2,901
- Location
- From Vt, in Va, going to MS
- Tractor
- Kubota's - B7610, M4700
Re: Need a tractor to lift a ton on the 3 pt
I need to pick up the logs and lift them onto my mill with my 3pt 1 ton rated pallet forks.
I'd LIKE to be able to afford a tractor that could do it with the FEL, but that usually means a more expensive tractor
Just envisioning someone trying to carry a 12' log perpendicular to the direction of travel thru the woods has me ROFL.
Tractordata, and many manufacturers, may only list 1 rating on their web sites. I can ASSUME that is at the pins and not 24" beyond, but that is only an assumption. Sometimes Tractordata doesn't list any lift capacity. I don't know if some publication has data like that compiled similar to what Trailer Life does for tow ratings. I was hoping someone had a link to data like that.
Thanks for the pointer to the MF.
/edit - special thanks because they have a comparison "engine" which lists lift capacities not found on Tractordata - like for the John deere 4320 at the pin ends is 3130lbs
Again, this is only for a hobby.My rides - '95 Kubota M4700, LA1001 FEL :'07 B7610, LA352 FEL, Bush Hog SBX 48 box blade, 18', new Woods BH70-X w/ 16" bucket and Woods thumb, 3pt pallet forks, Dale Phillips PHD, Jinma 8" chipper, Winco 12KW PTO generator with a 2002 7.3L Ford F350 CC DRW 4x4 and '07 Hudson HSE Deluxe trailer - 5 Ton to haul
-
01-06-2013, 10:27 AM #13Elite Member
- Join Date
- Feb 2011
- Posts
- 3,836
- Location
- Frederick County, VA
- Tractor
- Kubota BX2360 & L4240 HSTC
Re: Need a tractor to lift a ton on the 3 pt
Could you build a ramp to your mill and push it on with the loader and a set of forks?
-
01-06-2013, 10:36 AM #14
Re: Need a tractor to lift a ton on the 3 pt
A MF 2605 lifts 3.195 at the ends
TractorData.com Massey Ferguson 2605 tractor information
-
01-06-2013, 10:44 AM #15Padawan Tractor Learner
Advertiser
- Join Date
- Mar 2009
- Posts
- 6,336
- Location
- NW Oregon
- Tractor
- Deere 317 & L118
Re: Need a tractor to lift a ton on the 3 pt
A lot of good suggestions on here. I'm not sure if you thought of it but I think a skid steer would do the job. I use my 317 deere to remove logs from the woods, all 8 ft long and ranging from 12"-24" in diameter. I usually will move several logs at a time (2-4), all using 48" pallet forks. Used construction machinery is cheap right now, I priced out a new 318D and they wanted $33k for one, so I got my 317 for 1/3rd the price with 1000 hours on it.
Plus skid steers are very maneuverable which is priceless in the woods. Check out your local craigslist/dealer websites/machinery trader for prices. My 317 with the rear weights is rated to lift 2100 lbs. Just my
My Fleet:
2004 Deere 317 Skid Steer Loader
66" Construction bucket, imatch QA adapter, CU72 Jake Rake, Middle Buster, 60" Landscape rake, 54"x 48" Pallet forks
2005 John Deere L118
42" deck
Check out my rakes: www.Jakesimplements.com
Check out the latest small engine I am working on: http://www.northwestsmallenginerepair.weebly.com
Member of the TBN "Young gun" Club
-
01-06-2013, 10:46 AM #16
-
01-06-2013, 10:47 AM #17Veteran Member
- Join Date
- Feb 2009
- Posts
- 1,476
- Location
- north of upstate ny
- Tractor
- Kubota L4240 HST Cab
Re: Need a tractor to lift a ton on the 3 pt
Is the three point going to lift it high enough for your mill?Ramp or tripod and chain-fall?
-
01-06-2013, 04:51 PM #18New Member
- Join Date
- Jan 2013
- Posts
- 2
- Location
- Schwenksville, Pa.
- Tractor
- Jinma Kioti John deere Rorer
Re: Need a tractor to lift a ton on the 3 pt
The sawmills I've seen have ramps and a winch/pulley system to get the logs up, are you just looking for a faster/easier way ? Pushing it up ramps with the loader should work, if your careful.
-
01-06-2013, 04:54 PM #19Veteran Member
- Join Date
- Jan 2010
- Posts
- 1,291
- Location
- Piedmont, NC
- Tractor
- Kubota L4610 & BX2230, Farmall Super M, Super A
Re: Need a tractor to lift a ton on the 3 pt
-
01-06-2013, 06:43 PM #20Platinum Member
- Join Date
- May 2012
- Posts
- 975
- Location
- .
- Tractor
- .
Re: Need a tractor to lift a ton on the 3 pt
Mahindra tractors lift well. Start your comparison with the Max28XL and models higher than it. Click on the "Tractor Comparison" tab in each link:
Mahindra Max 28XL 4WD HST - Mahindra Tractors - Heavy Duty, Value Packed Tractors. Built Tough to Last with a 5 year Warranty
Mahindra 3016 4WD HST - Mahindra Tractors - Heavy Duty, Value Packed Tractors. Built Tough to Last with a 5 year Warranty
Mahindra 3616 4WD HST - Mahindra Tractors - Heavy Duty, Value Packed Tractors. Built Tough to Last with a 5 year Warranty"The only thing necessary for the triumph [of evil] is for good men to do nothing." Edmund Burke*
“If you continue in My word, then you are truly disciples of Mine;and you will know the truth, and the truth will make you free.” Ancient of Days
Similar Threads
-
Loader M7040 can't lift a ton
By pbooch in forum Kubota Owning/OperatingReplies: 36Last Post: 08-25-2012, 10:07 AM -
Long TON vs Short TON vs Gross TON!!!!!!!
By LD1 in forum Trailers & TransportationReplies: 36Last Post: 07-21-2012, 07:03 AM -
Harbor Freight one ton VS two ton shop crane
By sixdogs in forum Build-It YourselfReplies: 7Last Post: 03-09-2011, 09:49 AM -
1990 3/4 ton Suburban, Lift Kit, Swampers, 4.56 gears
By HHR in forum Private Party AdsReplies: 0Last Post: 01-19-2011, 09:08 AM -
backhoe+8 ton jack+3 ton come-along= minus one stump
By irwin in forum ProjectsReplies: 8Last Post: 07-18-2007, 09:10 PM


Reply With Quote

