Schulte 21 spline pto shaft

[JoelD]

Hi all,
Looking to purchase a used schulte blower

Does not have pto shaft, chute rotation set up nor three point frame

Can anyone tell me if the shaft is 1-3/8 21 spline? I counted 21 but did not have caliper with me to measure

Can I use an adapter to standard 6 spline an then use my tiller pto shaft?

I can make my own bracket for the three point and will make a rotation setup

Model is 7400

Thanks,
Joel

 

[Baby Grand]

These guys have a 1-3/8 21T to 1-3/8 6T splined adapter:
https://www.tractorpartsasap.com/PTO_Adapters_s/9763.htm

 

[JoelD]

Thanks Baby Grand, I'm thinking that is basically what I'll go with.

Would anyone be able to confirm the 1-3/8 21 spline on the 7400 Schulte?

I'll call them this morning, I'm sure they can tell me.

It is a nice heavy built machine, looking forward to getting hooked up.

Would anyone have a manual? Or parts diagram? I'm going to have to build the three point bracket and any detailed pictures would be great, including the manual chute rotation, I think I'll go with the cable wrapped around a manual cranking shaft.

Thanks again Baby Grand,
Joel

 

[5picker]

Would anyone be able to confirm the 1-3/8 21 spline on the 7400 Schulte?
I think I'll go with the cable wrapped around a manual cranking shaft.
Joel

Joel,
I can't confirm the spline but if you are interested in some pictures of a crank operated cable chute rotator (which I've converted to hydraulic) check out my thread HERE.

 

[JoelD]

Thank you 5picker.

I really appreciate the link, I was looking at it last night.

GREAT POST.

Thanks again for taking the time to post the link,

sincerely,
Joel

 

[hanson1999]

21 splines usually indicates the blower has to run of 1000rpm input speed. adapting to 6 spline 540 will run the slower at basically half speed....

unless the input shaft on the blower is just 21 spline because thats how they made it....

you better double check

 

[JoelD]

Thanks hanson

I noticed that in some other posts

The manufacturer states 540 pto speed

My tractor does both so I should be ok either way

Will speak with manufacturer to confirm 540, I saw the 540 speed in a PDF on the blower but will double check

Thanks,
Joel