OP
DIRTCUTTER
Silver Member
The photos are great, can you post the measurements of the dolly8561 said:It's not very complicated, but it sure works well, and it's built rugged. Basically, I just slide it under the backhoe and set one end under the frame, and the other under the bucket. I then use the dipper hydraulics to take the weight off and it's free. I use the red tie-down in one of the photos to run between the stabalizers to make sure they don't leak down. The real beauty is in putting it on. With all the weight on rollers, you can push it to exactly the spot it is needed. Believe it or not, it can be pushed with one hand. Here are the photos.