Anyone know what the max PSI is for hydraulic output on a CK35? I'm planning to build an implement that will use hydraulic pressure from one of the rear ports, to size the cylinder bore correctly I need to know what PSI I'm dealing with. I looked in the owners manual but it only specifies volume, not PSI.
Hydraulic PSI (for implement) on CK35
- Thread starter rjpotts
- Start date
Bearsixty7
Veteran Member
Seems like most CUT and SCUT are around 2500psi
https://www.kioti.com/wp-content/uploads/2018/03/US-LIT-CK10SE-ALL2-1-2020.pdf
Says loader relief is 2560. not sure that's the same model it jumped to.
https://www.kioti.com/wp-content/uploads/2018/03/US-LIT-CK10SE-ALL2-1-2020.pdf
Says loader relief is 2560. not sure that's the same model it jumped to.
Headwrench
New member
It's not that expensive to get a hydraulic gauge and QD end, plug it into your port and find out. Then you'll have a test tool :}