I crimped the fuel line that runs from the filter to the injection pump on my MF274 by over-torquing it. Agco says that they're no longer in production and Yesterday's Tractor couldn't find one either, so I'm hoping to find one from salvage before trying to build my own, starting without any of the parts, tools, or knowhow.
It's item 10 on this diagram, which is listed as part #1825177M93.
All clues to finding a replacement are welcome! Or, if I should just bite the bullet and rebuild it, I'm eager to hear tips on which bending and flaring tools are good enough to get the job done without breaking the bank.
Thanks!
It's item 10 on this diagram, which is listed as part #1825177M93.
All clues to finding a replacement are welcome! Or, if I should just bite the bullet and rebuild it, I'm eager to hear tips on which bending and flaring tools are good enough to get the job done without breaking the bank.
Thanks!