americium100
New member
I’ve been looking for a way to put rubber track shoes on my little Lamborghini loader. I have original equipment clip on steel street shoes for it but they are a little worn and it will still mark up asphalt and concrete pretty good. And they are only in every other track plate. Here’s a pic of them.
I found this company online that makes both clip on and bolt on rubber shoes but Lamborghini isn’t on their list. I will contact them to see if they are able to make a set but I wanted to cast a line out here to see if anyone has other sources or ideas. I also looked for 2” thick x 3.5” wide x 14” long rubber (bars or plates to cut to that size) to make shoes from. Not a lot of availability on that that I could find. McMaster Carr has some raw sizes, close but not close enough and quite pricey too.
So I’m just fishing for ideas. I’d like clip on convenience but homemade will probably need to be bolt on. I also want to put one on every track plate instead of skipping half of them.
I found this company online that makes both clip on and bolt on rubber shoes but Lamborghini isn’t on their list. I will contact them to see if they are able to make a set but I wanted to cast a line out here to see if anyone has other sources or ideas. I also looked for 2” thick x 3.5” wide x 14” long rubber (bars or plates to cut to that size) to make shoes from. Not a lot of availability on that that I could find. McMaster Carr has some raw sizes, close but not close enough and quite pricey too.
So I’m just fishing for ideas. I’d like clip on convenience but homemade will probably need to be bolt on. I also want to put one on every track plate instead of skipping half of them.
Last edited: