DLTTrekkers
Veteran Member
ANY HYDRAULIC FITTINGS BEING WELDED on the rodside of the silinder ? Make sure it can let oil tru !
tx1500 hydraulic help needed
- Thread starter keithf1hunting
- Start date
OP
keithf1hunting
New member
- Joined
- May 15, 2014
- Messages
- 9
- Location
- Andreas, PA
- Tractor
- Bolens/Iseki G174/TX1500F - Cub Cadet GT2550
Thanks all for the help and suggestions. It turns out that the previous owner put a smaller diameter lift piston on the plow. This resulted in the factory set 800psi not being adequate to lift the heavy plow. I adjusted the hydraulic pressure relief valve to allow 1200 psi and it lifts just fine. Can't wait to plow some snow with my new toy.