jeffreythree
Bronze Member
- Joined
- Dec 15, 2010
- Messages
- 55
- Tractor
- Kubota B6100E
I am just starting to mess around with welding with a little flux core welder after not welding since shop class many years ago. I have the top from an old '30s tablesaw with a busted arbor that I used to put practice pieces on and set up on sawhorses. It is about 21"x36" cast iron. Is the cast iron ok for a little weld table? If not, maybe use it as a support underneath a thinner plate top? If so, maybe this is a tip for others out there looking for a cheap top since I picked this up for free through the local freecycle group (thought I could fix it until I found a cracked, previously repaired casting) and regularly see motorless old ones for cheap on CL.