Shield Arc
Super Member
This isn't as easy as it seems. Then again I never did much Mig welding. But I got the idea when playing with my new to me machine, and my old LN-25. I like to go through and find the best settings for me with each machine and write them down in a binder, or on the face of the machine.
Anyway here is some playing around with 2 1/2-inch schedule 80 pipe, 6-G open root. .045 Lincoln L-56 wire. 20.5-volts, and 105 for wire speed , LN-25 set on low speed. The two cap passes were run uphill.
I had to run one side right handed, and the other side left handed.
Anyway here is some playing around with 2 1/2-inch schedule 80 pipe, 6-G open root. .045 Lincoln L-56 wire. 20.5-volts, and 105 for wire speed , LN-25 set on low speed. The two cap passes were run uphill.
I had to run one side right handed, and the other side left handed.