I tried searching for information on this, but came up blank. I think this is a pretty simple question, so here goes:
I just picked up a Lincoln AC 225 unit - used, like new condition. It doesn't have any supply wiring (cord) with it, and the leads are pretty short.
What size breaker do I need to run this welder? I've got a 200 amp service in my shop, with almost nothing on it right now. What size wire should I use to feed the receptacle for the welder (run will be less than 50' from panel to welder outlet).
I would like to lengthen the leads as well. The lead wires are pretty short and pretty small. I would like to have 30' to 40' of length. What size wire should I use for that?
Sorry if these are rudimentary questions. I've welded a little before with units like this, but it's always been in a somebody else's shop and everything was already set up.
Thanks for the help. Take care.
I just picked up a Lincoln AC 225 unit - used, like new condition. It doesn't have any supply wiring (cord) with it, and the leads are pretty short.
What size breaker do I need to run this welder? I've got a 200 amp service in my shop, with almost nothing on it right now. What size wire should I use to feed the receptacle for the welder (run will be less than 50' from panel to welder outlet).
I would like to lengthen the leads as well. The lead wires are pretty short and pretty small. I would like to have 30' to 40' of length. What size wire should I use for that?
Sorry if these are rudimentary questions. I've welded a little before with units like this, but it's always been in a somebody else's shop and everything was already set up.
Thanks for the help. Take care.