PowerARC 300

[DXN1EL]

Hey guys, I place an offer for the Everlast PA-300, and ten minutes latter I got a call, saying that my offer was accepted :thumbsup:


Now I need some rods, :cool2:

 

[Mark @ Everlast]

Glad you got what you wanted.

 

[DXN1EL]

what kind of rods do you recommend?

something like this?
http://www.homedepot.com/p/Lincoln-...ctrodes-50-lb-ED010114/100595309#.UffaxKzCaCk

 

[Arc weld]

You'll probably pay through the nose at Home Depot. Check around for prices. You might not need 50 lbs. of rod. I'd get some 6010 and 7018.

 

[Shield Arc]

My PA-200 loves ESAB's 10P-Plus 6010, and ESAB's Atom Arc 7018.

 

[DXN1EL]

Does all of the circuit beakers are the same? I mean, is there a specific breaker for a specific panel?

What size of breaker does the PA-300 need for maximum performance?

 

[yomax4]

The breaker has to match the brand of panel.ie: Square D, SquareD Homeline, Cutler Hammer, more. Look at your panel. The brand will be on there somewhere.

 

[DXN1EL]

The breaker has to match the brand of panel.ie: Square D, SquareD Homeline, Cutler Hammer, more. Look at your panel. The brand will be on there somewhere.

10-4

 

[Mark @ Everlast]

You need to download your manual from online located here: http://www.everlastgenerators.com/downloads/PowerArc-Series-140ST-160-200.pdf

It gives you all the specifications you need and covers all the information about hook up connections etc.

 

[DXN1EL]

Thanks Mark for the link, Can't wait for the welder to arrive. I need to wire the 50Amp outlet, get a plug and some rods.