rock2610D
Silver Member
Can anyone tell me if this will work?
I have a compression tester that goes to 300 psi. I have been able to screw the end of the compression tester into the fuel intake port of one of my old injectors.
If I remove the needle in the old injector will that work? Or should I remove the entire middle section of the lower injector? Better yet is there any way this could work. I realize I could have way more than 300 psi but if you think this will work all I will have to do is purchase a 5 or 600 psi gauge.
I have a compression tester that goes to 300 psi. I have been able to screw the end of the compression tester into the fuel intake port of one of my old injectors.
If I remove the needle in the old injector will that work? Or should I remove the entire middle section of the lower injector? Better yet is there any way this could work. I realize I could have way more than 300 psi but if you think this will work all I will have to do is purchase a 5 or 600 psi gauge.