Anonymous Poster
New member
- Joined
- Sep 27, 2005
- Messages
- 0
Today, I decided to start and run my 1610 for a while to make sure the battery does not die. It had been about three weeks since I started it last. While it was running with me sitting on it, I decided to ride around my property. My 5' finish mower (405#) was attatched to the 3 point. I raised the mower as normal. I have learned not to raise it very high and then go running around my property which is fairly sloped. (another story) Anyway, I always set the mower on a couple of timbers when I park the tractor to keep the mower off the ground. When I backed into the parking position, the mower was not very high off the ground so I raised the 3 point to set the mower on the wood but it would not raise the mower more than about 1 foot off the ground. The hydrolics are trying but it just won't raise the mower higher.
This is my first real tractor and I only have about 3 hours operating time since I bought it. Also the first hint of trouble with the 3 point. I checked the transmission-hydraulic fluid level and it is clean and full.
Any suggestions? /forums/images/graemlins/confused.gif /forums/images/graemlins/confused.gif /forums/images/graemlins/confused.gif /forums/images/graemlins/tongue.gif /forums/images/graemlins/tongue.gif
Gary
This is my first real tractor and I only have about 3 hours operating time since I bought it. Also the first hint of trouble with the 3 point. I checked the transmission-hydraulic fluid level and it is clean and full.
Any suggestions? /forums/images/graemlins/confused.gif /forums/images/graemlins/confused.gif /forums/images/graemlins/confused.gif /forums/images/graemlins/tongue.gif /forums/images/graemlins/tongue.gif
Gary