Here are the legible decals on my RS1400 tiller: Lube, and YM2000 Setup. (The tine decal is illegible.)
View attachment 222362 View attachment 222363
Also - tine decal photos for RS1303 and RSB1400(G). On this last one the bolt head is shown in the recess as Ernie said, and as shown in Mickey's photo above.
View attachment 222360 View attachment 222361
I have a question: The Lube and Setup decals show the rear wheels installed with the vertical axle supports at the outermost sides of the wheels. I had installed mine with the supports on the inner sides to reduce tearing up my orchard trees when I get too close. But the wheels can only 'steer' a very limited angle in one direction, not enough to prevent ridges/ditches when tilling a tight turn. Are the pins that limit the steering angle of those wheels supposed to be vertical to allow equal swing in either direction, or bent like mine?