hefleyrb
New member
I am trying to replace the left rear axle seal on my YM1700. According to my manual, there are 2 snap rings on the axle - inner and outer ends. I have removed the PTO unit for access to the inner end. I thought I could slide the whole axle out by removing the snap ring on the inner end ( I could then have the hub pressed off in a local shop.) However, I cannot see the inner snap ring - I assume it is behind the drive gear. I cannot slide the gear off of the shaft due to the differential locking mechanism (which is located on the left side also) being in the way. Am I on the right track here? What means do you recommend for pulling the hub with the axle in place? I am considering a 3-jaw bearing puller while heating the hub. Do you think this will work without breaking the hub? Is this a special seal or will NAPA likely have it?
Thanks
Thanks