yannie1700
New member
Hi,
I figured since i had all the hytrans drained while replacing my rear axle housing it would be a good time to check the hydraulic screen since I have never done so, after pulling the bolts and the assembly out i found that there was very little screen left. Since I have apparently been running this machine for a long time without the benefit of the screen is it an absolute necessity to have it there?? I have temporarily just replaced the cover since the spring and rod that runs through the sping kinda flop around in there also I have removed the o-ring as it was damaged. Am I going to damage my little machine by running it this way???
Thnaks again
John
I figured since i had all the hytrans drained while replacing my rear axle housing it would be a good time to check the hydraulic screen since I have never done so, after pulling the bolts and the assembly out i found that there was very little screen left. Since I have apparently been running this machine for a long time without the benefit of the screen is it an absolute necessity to have it there?? I have temporarily just replaced the cover since the spring and rod that runs through the sping kinda flop around in there also I have removed the o-ring as it was damaged. Am I going to damage my little machine by running it this way???
Thnaks again
John