I found a wiring schematic (at least I think it is for the 254) I will run a test as you've suggested. I did tract to the starter solenoid and had power to it. I check the ground wire for the panel lights on the gas tank. It appears intact. Thank you for your help.
Dear Forum,
My Jinma is basically dead. I get nothing. No lights, no start. The battery tests at 12.6 volts. I get the same voltage reading at the main fuse supply side. The battery is five months old I just replaced the iginition switch because I had panel light issues before and that...
Dear Forum,
My Jinma has basically no electrical power. The battery tests at 12.64 volts. The same voltage reading to the 30 amp main fuse. I had trouble with dash lights before so I replaced the ignition switch (being careful to replace one terminal at a time onto the new switch). Didn't...
When this one goes I am going with the Delco. For sure! I will get the smaller pully and upgrade the wire gauge to the 10. That all makes perfect sense. Thank you.
Bob,
I contacted the dealer I purchased the tractor from and asked them the correct wiring for the alternator. You were correct, he had wired it wrong. All three of the smaller wires were on the wrong posts. I put them on the correct posts and it works. No light after starting and I am getting...
Dear Bob,
I want to replace the alternator on my Jinma 254 with the Delco 10si single wire internal regulator. What do I so with the other 3 wires? Thank you for any help
TimP82
I have a Jinma 254. I want to replace the factory alternator with the delco 10si since wire alternator. What do I do with the other 3 wires connected to the alternator? I realize one has to be to the external voltage regulator. What do I do with that? Thank you for any help. I got...