Recent content by 94BULLITT

Splitter Wars is a collaboration between 8 YouTubers. There are 7 different types of splitters and a maul. This is not a competition. It is a demonstration of different types of splitters. Hopefully this will help people figure out what kind of splitter they need. Here is the line up: Splitting...

Here is a little video I made on ballasting your tractor. I show that it is important to ballast for use with the loader or 3 point hitch.

Here is a video I made on how to shift in and out of 4WD on the fly.

Would a CUT with 9.9GPM run a skidsteer harley rake? It looks like they require a minimum of 13 GPM. I assume it would just turn it slow but would it function right at a lower speed? Nobody here has a rental for a 3PH.

I got everything to do the 400hr service on the BX. I started on it tonight and I will finish it tomorrow, I'm letting the fluids drain over night.

I recently purchased 2 set of peerless tire chains. I purchased #10165 for a 10-16.5 tire, the front of the L4240. The other set was a 1062256 which was for a 18x8.50-10, the front of the BX2360. Snow Chains for Tires, Best Tire Chains, Truck Tire Chains Snow Chains for Tires, Best Tire...

I am looking for a set of tire chains for the front of the L4240. It has 10-16.5 tires. I would like to get something that is going to have lateral grip and make steering easier. I don't want studded/ v-bar chains or duo grips. I would like to find have net style tire chain. The only place I...

I am looking for a couple of adapter fittings. I need one that is male #8 British flat face to 3/4 male NPT and another one that is female #8 British flat face to 3/4 male NPT. Anybody know where I can find them? Thanks for any help.

Does it look like I have the WDH setup right? I'm setting on completely level ground in the pic. The jack was not supporting anything.

I have a snap on mig with a tig conversion for it. I have had it 3 years but have not used it much. I tried welding some 20 gauge on the lowest setting (50amps) and it burned through it. If I get a foot pedal will that allow me to lower the amperage for welding thinner metals like 22 or 24 gauge?

I figured out an easy way to remove grease and diesel smoke from your tractors loader. I made a video so you can see how it works.

The BX's in Europe have mirrors as an option. It would be nice if Kubota offered that option for North America. I thought I would start this thread and see how much interest there is. If it looks like there is some interest in mirrors for the BX I was going to email the link to this thread to...

Does a Kubota RTV have brake lights?

Could someone with a B2330, 2620, 2920 or L3200 or 3800 measure the overall height of the fuel filter assembly? This is the filter assembly I am talking about. Kubota Fuel Filter Assy Part #6A320-58862

What do you guys do for a 7 pin extension? I have seen 7 pin harnesses in varying lengths with the male end but no female end. Do you guys just buy one of these and put the female end on it and would that be the best way to go? I need an extension for the the tractor. Amazon.com: Conntek ROJ...