Recent content by AviEst1995

Hello, I hope you are doing well. Is there any chance you can label on this picture the Power, Tank, and Power beyond on the three block looking connections on the manifold? I think my connections could be wrong between the manifold and the loader valve. Thank you in advance.

Good news friends! I took the carburetor apart and cleaned it one more time and it’s running like new!! Thank you everyone for your help

Okay, I will give it another go this weekend. I’ll take a few pictures of it split apart too.

It's off a '50s Michigan 55A front wheel loader. Would I have to find the same exact carburetor to replace this one or could I just match up the size and mounting and I'd be good?

Thank you! Would the governor have anything to do with how it only runs when the choke on? I took apart the carb and cleaned it as much as I could and it still will only run on choke but I am able to rev it up now unlike before when it didn’t want to go past an idle.

It seems to be stuck open the way it is now

This is what I’m holding.. pic didn’t join first post sorry.

Can someone help me to understand what it is that I’m holding does on this carburetor? I know that right below it is my throttle and a little down to the left is the choke. Also this engine only idles with full choke and then barely wants to run past idle but I’ve noticed playing with the...

I was just thinking maybe that it had the wrong filter on it and I then replaced it with a similar incompatible filter and that’s the cause for low flow test. But would that similarly cause the lack of pressure?

Could a wrong hydraulic filter installed be restricting my flow?

Thank you, this weekend I’ll be getting new hoses and the new loader valve installed.. will keep you posted as to how it works

When I install new hoses do I need to let hydraulic fluid flow with the hose off to get air out or is that not necessary?

Would I be able to replace my diverter valve with this one here? https://summit-hydraulics.com/product/hydraulic-manual-actuated-lever-selector-diverter-valve-13-gpm-summit-hydraulics/

What is a PB sleeve?

If I had to guess P is power aka in and t is tank aka out and n that’s plugged would be for the power beyond?