It's a scam. Accepting and depositing bad cashiers checks can actually get you in trouble with the banking industry. They have their equivalent of the credit card bureaus. If you get black listed with banking, you will not be able to open / maintain a bank account basically anywhere. Doing...
After reading the replies from "JWR" and "Ed ke6bnl" I decided to replace the filter next to the engine also even though it appeared to have good flow through it. I actually used the lift pump to pump all of the fuel out of the tank until it was dry. I then replaced the fuel filter and...
Bled the fuel lines by loosening the bleeder bolt that goes into the engine until it pumped out fuel in steady stream no bubbles.
Removed air filter, very clean. Have had mice in tractor air filters in the past, no signs of intrusion for this one. Removed air hose after air filter going to...
Tractor was running perfectly, no issues at all. Used it for about 5 minutes, left it idling a couple minutes. Came back and it was off with clicking still going from fuel pump. Tried to start it. Turns over fine but never catches.
I replaced the fuel filter under the floor pan first. No...
Anyone know for sure if the transmission out of a BX2360 can / cannot be swapped into a BX2670? Will it fit and bolt right up without modification? It appears looking at Messicks that there are two housing versions for the BX2360, one of them matches part numbers to the housing for the BX2670...
Quick Hitch is the term Kubota uses for the piece that attaches to the tractor frame and holds the snowblower onto the front of the tractor. It has a hydraulic cylinder on it to raise and lower the entire snowblower. Kubota part number BX2751 is the quick hitch for these.
If I configure this...
As the title suggests, not sure what the part would be called. I do NOT want to add a standard third function kit to the tractor. What I want would be tied more to the snowblower than the tractor itself. I plan on changing tractors. I'll try to describe what I am hoping for below.
Tractor...
The frame that the bearing mounts into is is all the same part. Seems they revised the bearing style to an all in one solid block versus two metal flanges holding a bearing between them. I have swapped to the newer style all in one in the past without issues. I could not see how changing the...
Interesting. Can you read my private messages? Didn't think so.
This is also the time of year that many people are buying used snow blowers in preparation for winter. In July most people do not look for snow blowers. It's a seasonal thing when it gets cold and snows.
You do get the troll...
I figure if two of us have $180 chunks of metal that neither of use can use it might be a good idea to swap them at a cost of $10 to $20 shipping so that both of us end up with snow blowers that we can use. Total cost outlay $20 to $40 versus $360 between two people. I thought that would make...
That shaft (#1) is always the same part. You need to swap the same piece I am asking for to get the extra length. People often get confused on the two parts. If its short switch the #3 part to get the extra 3 3/8" inches. The BX2370 uses the longer 14 7/8" shaft. Measure #3 on yours, expect...
I have a Kubota BX2752 drive shaft from a snow blower that I bought. Looking to swap this for the longer BX2753 part. These are used in the BX2751 quick hitch for both the BX2750 series and BX5450 series snow blowers. Different models of Kubota BX tractors use one or the other. The rest of the...
I have a Kubota BX2752 drive shaft from a snow blower that I bought. Looking to swap this for the longer BX2753 part. These are used in the BX2751 quick hitch for both the BX2750 series and BX5450 series snow blowers. Different models of Kubota BX tractors use one or the other. The rest of...