Recent content by cj7

Check out E-conolight.com Very quality products at a good point. Warranty response is good also. I have used them for years for commercial projects. Oops.! I see plowhog mentioned them already.

I may have missed this amongst all the great ideas.... but A rockin sound system to listen to your favorite tunes!!!

Hit up your friends. Maybe they will chip in on a tub or two from your great purchase. I am thinking use some of the Mrs older tupperware for containers to take out of the shop. Have fun!

The label issue has me thinking..... so our yellow portable jugs would have to be labeled????? Good grief.

Dont know if this will help, but my tractor would loose power when brush hogging a steep hill. It was becausr the fuel level was low. The cure was adding fuel to the tank. I dont know the Ford fuel system but Id make sure to find all of the screens in the system and make sure they are clean...

Good to hear its fixed!

First neither one is perfect for all tasks. Think about what tasks you wish do to the vehicle or tractor or whatever you want on the lift. Then base your purchase from there. As for the concrete thickness. .. each lift manufacture should have the requirement in their installation manual. Look...

Does your tractor sit alot between use? Is it exposed to weather? I one the same machine. I would spray some PB blaster on the pivot points and rods that are outside of the case. Adjustment would be next. If I recall correctly there is an access door to the clutch on the clutch pedal side of...

Everything I have. Except not everything was available 25 yrs ago!

I run a 5ft woods brush hog with my L2500 and a 6ft finish mower. It handles them fine most of the time. If the growth is too thick then I need to slow down. They still will cut. Look up on the tractor data and see what your machine is rated to handle. I would stay with what is reccommended or...

So many points to consider....lol I owned 7 acrs for 25 years in Western PA. Snow levels would be different from year to year. Had concrete about 150ft and a gravel lane about 1/4 mile. No trees so if it was windy..... I would let a snow base build on the gravel drive if possible. I kept the...

Ill throw my 2 cents in on this one. ( I tend to over think things as well ) Assuming your ground water and surface drainge around this are is good then.... My concern would be the low point or the area of most fill having enough compaction and support over time. If its one corner consider...

Love the random set of eyes...lol And that literal stick figure that has those growths for hands and a head....lol... too funny!

I had it in a 32x40 pole building in western PA. What I learned. My builder did not insulate my slab well enough. Should have used something better than the double bubble wrap. Also should have insulated the perimeter 2 to 3 feet down with 2 inch foam board. Inside a ceiling should have been...