Recent content by F15DOWNER

Hi I just purchased a generator head that I would like to run with my tractor. The gen head needs to turn at 1800 RPM. Does it make a difference in PTO HP within the 3 ranges? I don't want to set it up at a 2:1 ratio in range 2 and not have enough power to run it. Question 2 At what Engine...

I found a set of wheels and tires on Ebay for $110. I measured my wheels and it seems like they will fit my F15D. Is $110 plus shipping a good deal on these? I have seen the tires advertised and thay are always around $60 but I have never seen a set of wheels advertised so I don't have anything...

I'm welding up some brackets for a loader and some people have told me that I have to be careful that I don't fry electrical components and arc the bearings in the motor. Is there any truth to this? I'm using an AC stick welder. My original plan was to tack them in place and remove them for...

Hi All I would like opinions if a used YFL675 Yanmar loader would fit on my F15D. I'm aware any loader might require a few tweeks. Tom

I would like to get some new blades for my finish mower and the people who sold it to me went out of business. Does anyone know of a place to get replacement parts for this type of mower in the US? Someone told me that the Caroni TC590N blades will work, but I would like to verify that before I...

All Has anyone had any experience with a Helpmate loader? www.compacttractorconnection.com/ctcloaders.htm I want to put a loader on a F15D and most of the others seem to be a little heavy for a small tractor, this one looks a lot lighter. I have never had a loader on a tractor, so I figured I...

Does anyone know of someone that makes a belly mower that runs off of the PTO shaft? I have seen them in pictures but can't seem to find anybody that makes them. Tom

Does anyone know where I can get a push button release overrun clutch for an F15D? I would like to have one that I can remove easy, whithout pounding out the pin all the time. Tom

I have an F15D and the battery isn't charging. I have read allot of stories about the voltage regulators going bad very easy, and I have searched through endless posts about charging. The tractor has 340 hours on it and is in very good shape. Is their anything I could test / check before I order...

Does anyone know where I can get a set of rear turf tires and wheels for an F15D? My local tire shop has some tires that will fit on my rims but I don't want to take my rice tires off, I want to be able switch back and forth. Any parts tractors out there that you would like to part with the...

Do any of you know if I can get an FEL for an F15D? So far I haven't heard anyone talking too much about the F series tractors. Are they just too new in the US and the market isn't there yet? I know an F15 is a little light but, with a little weight in the back it should do OK. How about it...

Does anyone have any suggestions where I can get a rebuild kit for my 8N other than Ford NH?

I already own an F15D and I'm looking at another tractor that's a little bigger and I ran across a F175D. Is this a typo? Has anyone ever heard of this model? The tractor looks very nice and has 415 hours on it. Is this tractor an F17? Is their such a model. Picture attached.

Can anyone tell me what lights are what, on the instrument panel of my tractor? 1ST, (?? over temp) 2nd (Water Level Low) 3rd (Oil Pressure Low) 4th (Generator) Picture attached: I know in most cases, by the time the light comes on it's too late, but I would like to know anyway.

I have an F15D. Does anyone out there have any info on this tractor, like Filters, oils. I would also like to get an extra set of wheels for turf tires, but so far I haven't been able to find any, short of having someone make them for me. Any info would be appreciated!!