I realize this is an old thread but it still ranks high in my google results so I figured I would link to what I have gathered for future visitors.
https://www.joemalovich.com/2021/03/30/steiner-manuals-that-i-have-found-so-far/
Looks to be in good condition, seller says it starts and runs but needs a seat and a belt (didn't specify which belt). Asking $2600, good price? Pennsylvania.
Seller had originally listed a B2400 with loader and mmm on a online for sale site for 5,800 in non-running condition, I couldn't justify it at that price. My dad said I should lowball, I did and seller accepted $4,500, this was a sign of things to come.
Yesterday I go to look at it and maybe...
I've attached a picture of some suggested changes that should be made for strength and crack-propagation reasons. Also some guys like their tine teeth to meet so they can pinch small offending roots/rocks. Source: I'm a mechanical engineer and amateur MS Paint user)
SN M00318X014319
I don't know when it was made, 1966hrs, just purchased for $1250 with 50" deck SN M01013X016126
When starting I need to physically push the direction lever over in the neutral slot trigger the switch, on my 314 I just need the lever to be in neutral without pushing it. Is there...
Rough outline:
48" wide maximum - Fit in the bed of a truck in lightweight configurations/general manuverability
Aluminum SSQA/Loader Arm(s) - For maximum lifting capacity
4x4 - hydraulic hub motors nested deep inside large offset wheels with short sidewall
All Wheel Steering - with the...
If you want golf-course fairway smooth then use what a golf course uses, a verticutter. This is like a flail mower that has vertical knives that go down into the thatch/dirt pulling up material. High spots will be dug deeper than low spots leaving the sod intact. It depends on the verticutter...