Had intermittent start on our 5010hst and it was the small power supply lead from battery - the crimp on the spade terminal in the connector had corroded so that wire would occasionally make / break connection... Temp fix for now till I get proper terminal of another single wire block
Had cab off Mahindra 5010 to repaint including peddle bracket assembly...all back together but no reverse ...when keyed on the F light is illuminated and I have to move both pedals slightly to register N so it will start ...
When idling, F light remains illuminated but cannot get R to engage...
Have cab off a ready to paint - wondering what these two linkage controls are for?
Its on a 2014 Mahindra 5010.
First one is located above the rear axel on the right side between the 3pt lift arm and the 3pt raise / lower linkage control assembly.
Second one is the inboard portion of the 3pt...
Previous owner used for snow clearing wasn't big on preventative maintenance....
Have cab stripped down and removed to be sandblasted and coated - either bedliner or epoxy .. Heads up to check the bottom of the middle cab post - its not sealed on the Mahindra so all that nice salty water...
Recently purchased a used 5010 cab model mostly for snow removal an light utility work. One of the boom rams has a leak and wondering if there is any other seal kit to fit ...$250 cdn seems from the dealer / mahindra is rather excessive for what should be a $50 part. Considered replacing with a...