Recent content by mitchash

One is 3/4” smooth bore welded to shaft. The other is a 1” smooth bore that has a shear bolt through it.

I have a 2014 Max28XL with the 60” deck. I messed up the driveshaft on the mower mowing too high grass. I was told by the Mahindra dealer it would be $1000. to replace! I took it to a drive line rebuilder and they didn’t want to mess with it. Said they couldn’t get parts. I could fix it myself...

I have a Primeweld plasma cutter CT520D it’s a non pilot arc machine. It works great but it would be nice to have the pilot arc. Especially after using the plasma cutter at work. I thought I read where someone was able to convert non pilot arc to pilot arc? Is this possible? If so is it...

It never ran on batteries. It has a 50 foot cord on a reel. My guess is it ran on 3 phase 240 or 480 volts. Was used in a warehouse that couldn’t have gas engine. It came from the factory like that. Frame and everything is the same as a gas or diesel model 600.

I might be getting a Bobcat M600 electric skidsteer? Has anyone ever converted one of these to gas? If so what engine is suggested? What all is involved? Cost? Is it worth it? Anyone have the specs on the electric motor? We have 3 phase 208 voltage at our shop (just to try it out). I haven’t...

In the northeast towards the end of the mowing season it gets dark early here. By the time I get out of work and try and finish mowing it’s getting too dark to see very well. Lights would be very helpful!

Anyone install led lights on a Toro 54”Timecutter MyRide zero turn? I see Toro makes a light kit for it, but I can’t find any available and it’s a bit expensive. Thanks

I looked up the Max26 loader, haven’t found specs on the cylinders yet. But, the price for each cylinder was over $400.! There is a left and right and have different part numbers. I also looked up the quick attach part and that is now over $800.! The loader frame looks much different than the...

My backhoe seems a little weak too. I would like to put a pressure gauge on my hydraulics. Any suggestions? Thanks

I think the quick attach part from the Max 26 would fit the Max 28 loader. Im not sure about the curl cylinders. I might have to stop at the local dealer and do some measurements. I did price out the Max 26 loader quick attach and it was close to $600. but that was a few years ago.

I couldn’t find a price on the WR Long adapter.

Even if I could adapt the forks to mount on the three point hitch would be a help for moving pallets and stuff around.

Yeah, my loader curl is weak. I seen somewhere on here someone upgraded them to bigger cylinders.

Looks like mine are the class 2, 16” ones. They are smaller.