Recent content by PerryG

What part # is that in the diagram?

That wasn't the problem. It's getting fuel to the injectors but just not enough. There is a small cylinder plunger that goes in the return, Does it need to move freely inside inside it's housing because I have to tap it out . It's part #7 in the diagram and it goes inside part #8

Thanks for the reply. I just now got it cranked. I had the throttle wide open, closer pushed in, Had all the injector lines cracked. Turned it over as soon as fuel started coming out #1 and #2 I closed them and sge cranked. Took a few seconds to come out of #3. Now the problem is that it's...

I recently replaced a few seals in the pump. I replaced the: - large o ring on the head = gasket on fuel inlet - main seal(with spring facing inside) - o rings on the throttle and stopper shafts - strainer and fiber washer where the return line comes in - control cover gasket - all the washers -...