I was able to get it by bending the od in, as Zebrafive suggested, and then used an adjustable seal puller to pry it out. Pulling with pliers was not working. Below is the puller used.
I’m not sure what the arrow refers to, but there are no threads on the oil seal. Upon closer inspection it does appear that I am removing the rubber portion from the metal portion of the seal itself. Which explains why it seemed glued to it. Is there some sort of trick to get these out? I don’t...
I am attempting to replace the PTO shaft oil seal on my 2020 and I cannot get it out of the quill. I can only seem to remove bits and pieces at a time. Attached is a picture of what I’m dealing with. Is there a chemical out there that would dissolve it or help speed up the process? I’m about to...
I have a 2120 and diesel has recently started leaking from the fuel injection pump. It looks like it is leaking from one of the fuel pressure lines or somewhere on the bottom around the speed advance. I know I can replace the washers on the pressure lines if it is leaking there, but I am not...
Pumpguy, are you saying I need to replace the flex ring on the pump drive shaft? Also, do I need to do anything with the timing before I remove the pump?
Below is a pic of the pump numbers
I was mowing with my 2020 yesterday and after about 30-40 minutes it suddenly lost power. RPMs dropped and a puff of black smoke came out of the exhaust. It didn't stall and if I sat at idle for a minute I could continue mowing. Then it would occur again after only a few minutes of mowing...
I have a JD 2020 that has a very stiff throttle and I was wondering if anyone knows how to reduce the tension on it. S/N > 62,925 so I don't believe it has the tension adjustment nut and I cannot tell from the Parts diagram where you might adjust the tension. The JD service manual only...
I have a late 60s JD 2020 with power adjust rims and I'm thinking of replacing the retaining nuts and bolts that hold the clamps on. I've managed to loosen them enough to widen out my tread width, but I've had to use a breaker bar and a 3' pipe to get them loose. I cannot get the nuts to move...