Recent content by sos1

I'm looking for a design to convert an under belly mowing deck to a front or rear mount finish mower. I have a motor to power the deck.

It cuts about 1/2 grass and just knocks down the other 1/2. I don't understand. HELP

Looking for simple pull behind rock picker plans for lawn tractor with hydraulics.

Anyone ever do this? Wheels or tracks?

This mower will not crank (has a new battery and new ignition switch) I checked the 20 amp fuse, safety switches for seat, FNR shift, park brake, PTO. I took the starter solenoid out and checked it. What have I missed??????????????????

Would the stub shaft from Honda 13 HP fit ?

Has anyone built one that attaches to the stock bucket?

I'm building this out of heavy gauge steel sheet metal. How small should the gaps be between the impeller and the housing?

I'm considering using a chemical tote as the dump trailer for my leaf vac. The tote is supported by a metal "cage" on all sides except the top. I would like to have it dump through the top. I need ideas for the dumping system.

I purchased a 14 1/2" Giant Vac impeller from Ebay. Then I started pricing 8" vacuum hose and almost fainted! $10.00 to $15.00 per foot. Where can I find cheaper alternatives; maybe used hose. HELP!

What's the easiest or best way to get on and off my 430? Keep in mind I'm 64 years old and not as graceful as I used to be. Also, what are the steps for removal and mounting of the mower deck? One last question, the left rear axle seems to leak a little oil. Does the bearing have to be replaced...

What is the best impeller design for a Billygoat type vacuum that will suck up leaves, cans, bottles, sticks, etc.?

I need help with ignition switch. The engine has a red wire (alternator)that is not wired into the 5 prong wire plug. There is a 6th prong on the switch. I connected it there but no luck. The engine cranks but won't start. There is no spark. Help!!!!

What would a wiring diagram of the "bare necessities" for operating look like? I need to keep it running until I can afford a new wiring harness. The old wiring is shot!

Can I connect 2 cylinders to the same control valve if they are moving the same lever?