Thank you!!!
I had not been able to find it in the drawings. Might be that I had been looking at the wrong drawing.....
Good drawing + three minutes to find the sensor and plug it back in = Problem Solved
Thanks again!
Is there any way, short of a gauge, to get an idea if the pressure is really low?
Hydraulics performance?
Shuttle behavior?
Any thoughts on the location of the sensor?
Thanks.
Hey Everyone,
I was out moving some brush this morning when the "low trans pressure" light and buzzer went off.
I wasn't sure what that light meant and drove the tractor a few hundred yards and it seemed to drive ok. Forward & reverse worked.
I have checked fluid level and for any signs of...
THANK YOU!!!
The advice and the parts diagram are both appreciated.
It looks to me like I may be able to replace the broken shaft Without major disassembley.
I feel pretty good about putting it back together except for one (BIG) item.
The shaft that the forward end of the lower bar pivots on sheared off. I know that shaft plays a part in some of the fancy functions that I don't currently use.
Splitting the case to replace the shaft looks like it...
Hello Everyone,
I am glad I found this place. Plenty of great info.
To get one thing out of the way.... Yes, I am stupid. :)
The cotter pin that secures the big pin that connects the lift arm to the lower arm came out. That allowed the lower arm to drop to the ground. Not a huge problem...