Recent content by tom63

I bookmarked that Weingartz site. Nice, clear diagrams. Thanks!

Thanks ChasHM. Your pictures are a great help. So basically I need to repair the hose between 1 and 2 and replace the hose between 3 and 4. I think I can handle that! Thanks again for taking the time to take the photos and reply. I looked all over the Net and came up with nothing!

Thanks for the reply. Yes, my cub has the Mitsubishi 1.1L 3-cyl diesel engine. Probably similar or the same as the 7275. A picture would be great! I'll look at the Weingartz site also. Thanks again.

Mice ate some of my rubber hoses in the engine compartment! I see 4 open ended hoses. One is the breather hose to the Valve cover. Can anyone tell me what attaches to what or find a diagram of the correct routing?

Looks like I owe you a beer RNeumann! Did a bit of disassembly so I could see what I was doing and soaked everything in WD-40 and penetrating oil overnight. Today I did some prying and twisting and after a short period the one stuck valve (photo below) popped right up! Ready to roll again...

7 hoses total...

I was moving some dirt today with my cub Cadet 7205 and struck a buried rock; not real hard but now the joy stick won't move forward or back. Ok left/right (bucket curl) but the stick seems to be physically stuck and won't move at all fwd/back, engine running or not. I think the problem is...

I have a Cub Cadet 7205 and the lift lever for the 3 point hitch was getting harder and harder to move. Actually had to use two hands to move it. Also the lift arms were not going all the way up or down. Tried lubing all the linkage, checking fluids, etc. Finally tried shooting some (a lot!)...

Bought this WW Grinder T20 at a barn sale not knowing a thing about it but have been wanting something to attach to my Cub Cadet tractor7205 to grind up piles of brush/limbs that have accumulated around the property. A 1982 brochure came with it that states it is an Apache Scout T20-540. I...

The fuel gauge on my Cub Cadet 7205 recently started reading about half of what's in the tank (full tank reads 1/2 tank, 1/2 tank reads 0). I cleaned all the contacts/grounds that I can find and ohmed the sending unit. It reads from about 16 ohms to 116 ohms when the float is moved from one...

I am going to replace the glow plugs and the Glow Controller on my used (but new-to-me) Cub 7205. Can anyone tell me where the Controller is located?