Search results

Results 1 to 6 of 6
  1. K

    IH 584 pto not engaging

    would that be causing the lack of hydraulic pressure on valve?
  2. K

    IH 584 pto not engaging

    bought an ih 584 and the pto lever was stuck on when purchased got it all freed up and it engages well and the plunger works up and down, but the pto will only spin at high rpm and can be stopped with a 2x4 with light pressure, put pressure gage on the line coming from the valve body where the...
  3. K

    john deere 301a

    thank you, when you say the return can go to the trans case, is a specific plug for that?
  4. K

    john deere 301a

    working on installing rear remotes on a john deere 301 a, hoping to use a generic aftermarket set up to save on cost. main issue is knowing where to plumb into the tractors hydraulics to go to the valve body. any info on how to find which ports to use would be greatly appreciated thanks
  5. K

    john deere 301 a

    thank you for your advise, ill definitely give that a try, so i did use the rear pto with a bush hog like it is, you have to engage the pto when the tractor is off then start it with the pto engaged but it is quite hard on the starter cranking all that over at once, being it is working like...
  6. K

    john deere 301 a

    i have a john deere 301 a tractor that when trying to engage the rear pto depressing the clutch does not disengage the pto drive and it doesn't allow you to flip the pto lever to the on position. pushing the lever forward only causes it to grind gears, the clutch works fine for the transmission...
Top