Search results

Results 1 to 50 of 84
  1. RNeumann

    Splicing underground wire

    The wire doesn’t have to come to the surface.....just the lid of the box. And they make box extensions if you don’t want to make something to be below the box.
  2. RNeumann

    Corona Virus # 3

    This seemed like good advice. Be cautious......but not afraid.
  3. RNeumann

    Corona Virus # 3

    I’m not a FB guy but I was sent this screen capture......about sums it up
  4. RNeumann

    Corona Virus # 3

    The coronavirus is more common in animals. It has crossed over to humans in different forms over the years. This version “they think” crossed over from either a cat or dog in the Wuhan market in China. This is from the CDC website-
  5. RNeumann

    Mahindra 2538 HST max fork lift weight?

    I have the 1538 and a set of SSQA forks. I think the lift is similar. The lift cylinder angle actually makes the lift capacity worse when it’s close to the ground. I don’t think you will be lifting those pallets- or even coming coming close. I’d say the post above is about right- #1000 I can...
  6. RNeumann

    Cross Over or DRV adjustment

    I have a snow plow with a 2 hydraulic cylinder angle adjustment. I installed a cross over relief valve and would like to “properly” adjust the relief valve. Is their a way to do this with just Tractor hydraulic pressure? I know I can push one side against a rock and adjust the relief by “feel”...
  7. RNeumann

    For those with trail cams - cell upgrade

    Spypoint Cell-Link Cellular Attachment - YouTube They have a free plan (something like 100 pics a month if I recall) and obviously paid plans. You pick Verizon or ATT depending on what works best where you want the camera. It’s not tied to your existing phone so you can pick whichever. I have...
  8. RNeumann

    Snow Attachments Video- How a snow plow is made

    Video- How a snow plow is made How It's Made: Snow Plows - YouTube
  9. RNeumann

    Remote temperature sensor/monitor??

    I do this too!
  10. RNeumann

    Snow Attachments ATV and Vehicle Snow Blower

    I saw one of these the other day and am passing it along. FEL mounted, vehicle mounted, ATV mounted etc. Not cheap, but it is a good solution for some. SnowHogg 2 - YouTube Boss Hogg 40HP Snow Blower - YouTube
  11. RNeumann

    Buying Advice TU 2100 Upper Final Drive Gear

    I’m looking for the upper final drive gear. It’s in the front axle and is the one on the end of the axle shaft. Mine is stripped. Thx
  12. RNeumann

    Improving a Pellet Stove

  13. RNeumann

    1626 Battery Leaking

    From the photo of mine it looks like a group 34. The part number is 34/78-980.
  14. RNeumann

    Who makes the longest lasting stain

    Here is consumer reports recommendations- I’d also look at the stains they use for log homes.
  15. RNeumann

    New PVC glue

    While I’m not in the wholesaler everyday anymore, I do stay somewhat up to date on products. I saw this and it caught my eye. I have no association and haven’t used it personally. The EASIEST Way to Bond PVC Pipes and Fittings!! - YouTube
  16. RNeumann

    Fence painting - paint and device

    A lot of updates to paint in the last few years. They have paints that claim to have the primer in them. Otherwise I’d Prime first. Two coats total either way. Home Depot paint has been rated very highly by Consumer Reports. I’d stick with that. An airless sprayer is definitely the way to...
  17. RNeumann

    Show Us Your Favorite Vises

    I read the heading and was going to post a photo of booze and women! My favorite is the Rigid Tri-stand. I also have a standard 6” vise mounted on an old big rig brake drum. Both are the same height if I’m doing something long.
  18. RNeumann

    Joystick cable adjustment....maybe!

    I’m borrowing the neighbor’s tractor which is a 10ish year old Kubota probably in the 40-50hp range. It has two interesting things happening. 1- if the 3 pt control lever is all the way up the loader controls are very slow. Moving the lever down even a small amount brings back full loader...
  19. RNeumann

    Human powered log splitter.......not an axe!

    Well YouTube does it again! It has forgotten more than I know...... Amazing homemade manual wood splitter Best woodworking skills Ep4 - YouTube
  20. RNeumann

    Metal roof - Ice / Snow Guards?

    They make some gutter guards/gutter helmets that would have the snow sliding over the gutter. Stopping the snow on an entire 4/12 metal roof has a very special name.......asphalt shingles!!
  21. RNeumann

    Septic / Drain Field Issues

    Should be something like this on the inlet and outlet.
  22. RNeumann

    Spider Invasion

    I use both of these together and get 4-6 months. The ortho is good for most things but I added the other when I had a hard time with flees. Read the directions. The ortho has a much higher strength for around the foundation. I spray inside and out. About $25 will last me several years- I do...
  23. RNeumann

    Tractor Washing

    I understand a steam cleaner or pressure washer will do wonders for cleaning the tractor. I’m just wondering if someone has found anything else that is serviceable? Dawn soap, simple green, canned degreaser from the auto parts store etc.
  24. RNeumann

    Air Nozzle Tractor Inspection

    To start- I’ve always been one who looks over my vehicles (sometimes required by law) on a routine basis. I’d do the same with the tractor. I’ve caught a few things early that saved me some hassle later on. I’ve been doing some work in moon dust lately- it sucks! The first day I finished I...
  25. RNeumann

    71M MIG Wire

    Anyone tried the 71M wire for MIG? I do mostly tractor/farm type fab and repairs. This seems like a good fit.....on paper anyway. Just wondering if anyone has used it and could compare it to anything else. Maybe it’s more Like XXX stick or it’s not worth it for a homeowner or it’s the greatest...
  26. RNeumann

    Tired of the battery acid (optima battery)

    After constantly chasing spilled battery acid all over the front on my machine I fixed it. It seemed I was spraying neutralizer all the time with little luck. The latch even started showing signs of damage. Once the old battery was removed, I cleaned everything and repainted it. The Optima is a...
  27. RNeumann

    3-Point Hitch Bent, broken telescoping anti sway arms on Mahindra.

    Well I had the temp fix for a few weeks and finally found a nice “permanent” replacement. So far so good. I used the box for an hour or so to both push and pull and they seem to be holding up fine. Time will tell! I found a few bushings to go from the 7/8” hole down to the 1/2” pins on the link...
  28. RNeumann

    Box Blade Receiver Project

    This was fun little project. I have a little Jeep trailer I can pull around for firewood etc. I got the shackle mainly to keep dirt out of the receiver. The receiver is a Curt brand (made in the USA) and was available online. The shackle was also an online purchase. Total with both parts was...
  29. RNeumann

    Oil & Fuel 1533/1538 50 hour service

    Some tips for the 50 hour service. Mahindra 1533/1538 50 hour service - YouTube
  30. RNeumann

    3-Point Hitch Bent, broken telescoping anti sway arms on Mahindra.

    Or I’ll use one of these two options-
  31. RNeumann

    Locating gopher tunnels in sand?

    Oh yes she is loved!
  32. RNeumann

    New Kubota B2650

    I have a Mahindra 1538 which is a 38 HP machine. With pallet forks (not the clamp on the bucket style) I could lift the pallet in your second photo. I think the B series will be right on the edge with that load. With something on the 3pt for counter balance (I like my BB) and some light forks...
  33. RNeumann

    Snow Equipment Owning/Operating Blade Wing?

    I have a CUT with a box scraper that stays on all the time and a FEL with SSQA. In the winter I attach a snow blade that has hydraulic angle. The setup has treated me very well! What I’d like to add is a “wing” or something similar to either the box scraper or front blade that would add 18” or...
  34. RNeumann

    Recommendations wanted for a basic network camera

    If all you need is a fixed camera this should do. I have the pan/tilt unit.
  35. RNeumann

    Box Blade Hitch add-on

    I keep my BB on year round and would like to add a 2" receiver to move things around the yard. I'd also like to create a little cargo box to that I can attach to the BB when I want to carry the chainsaw etc. Anyone have photos of similar projects they have done? Looking for ideas- plus who...
  36. RNeumann

    Bleeding air or something else?

    I have a FEL that has had weak curl since new. It now has about 50 hours on it. The dealer added hydraulic top, tilt and rippers and third function- he was into the hydraulics. In my diagnosis I cycled everything several times- grapple, top/tilt/rippers, FEL lift and curl. I also swapped the...
  37. RNeumann

    Building firewood rack from pallets

    I use pallets for my wood. They look like the photo above except they are made from 1x4 with a rope across the top to prevent the sides from pulling apart. All I did was trim the top of the pallet so it was even with the 2x4s that stand on end. I glued and screwed the 1x4 sides on. I get the...
  38. RNeumann

    Floor scraper- near useless?

    I saw this the other day on a demo job site. The steel structure is about 3/4" plate. The scraper edge has bolt on blades that can he changed by loosening the bolts and sliding a new one in. The blades are laying next to the attachment. This thing looks like it is used mainly for removing vinyl...
  39. RNeumann

    Weak curl function

    The curl on my FEL is weak. I can often lift but not curl loads. Every other tractor I have used has been the opposite. What are the basic diagnostic steps to determine what is causing this?
  40. RNeumann

    Mahindra 1533/1538 FEL Curl

    I posted this in the Mahindra section. They suggested I also post here.
  41. RNeumann

    Loader 1533/1538 FEL curl

    Thanks for the info. In both these cases I could lift but couldn't curl.
  42. RNeumann

    Loader 1533/1538 FEL curl

    I have zero complaints about the lift capacity on my 1533. However, I've had a few incidents where I couldn't curl. In other words I could lift but couldn't curl. I've never been on a tractor that did that- it's always been the opposite. Before I go down the custom cylinder route I figured I'd...
  43. RNeumann

    Shop light suggestions

    I looked seriously at the LED UFOs and then found these on eBay. The folks were easy to work with. I was able to coordinate delivery dates etc via text. The lights work well. My shop is 25x40' with a sloped ceiling 17' on the high side and 14' on the low side. I chose to upsize 1 size based on...
  44. RNeumann

    Adding fuel from 5 gal container

    Posted the video in the Mahindra section but this applies to any tractor with the fuel fill in the hood. Mahindra 1538 add fuel to tractor - YouTube No Spill, Inc. Diesel Can, 5 gal., CARB Compliant - For Life Out Here
  45. RNeumann

    Oil & Fuel Easy option for adding fuel

    This is an option for adding fuel. It uses an "approved" filler. Mahindra 1538 add fuel to tractor - YouTube
  46. RNeumann

    Oh Deere

    Interesting article. I'm not sure which manufactures are doing this. Toward the end it looks like some states are taking legislative action to prevent this in the future. Tractor Hack: Farmers are harnessing hacked software for John Deere repairs | Fox News
  47. RNeumann

    Gate post metal type?

    I want to install a new gate post made of steel. I had access to "oil field pipe" where I used to live and it was great for fence building. It didn't rust to failure like the "standard" grade steel from the suppliers. I'm not sure the grade but I'm betting someone on here does! I'm after...
 
Top