Search results

I recently replace the oil pan gasket on my dad's IH 234 3 cylinder diesel due to leaks. Well...after install the pan seems to be leaking out of one of the pan bolts. Does anyone known what to torque the bolts to? I tried some rtv sealant on the leaky bolt with no luck.

Check out the attached pic...look at number 240...

I recently ordered 2 new Gladiator 6-ply rear tires for my BX2200. The old tires (Titan 4-ply) were dry rotted...one was fluid filled with a leaky repair plug in it...one was not filled but was leaking through a crack. Long story short, the new Gladiator tires were puchased for $68 each from...

I have recently been working on a 2002 (label on engine stated 2002) JD LV 4010 HST diesel with Land Pride FDR1648 finishing mower for a friend. The tractor had been sitting for quite some time, so he brought it to my garage and I have given it a detailed once over. So far, I have replaced the...

My dad's 234 just had the water pump fail. Pump seized up and burned off the belt. Just ordered both off of Ebay. Water pump looked to be original. I think the tractor was built in 1984.

See image below. I am replacing the axial ball (see white arrow in the image), but the hydraulic steering ram (see black arrow in the image) is spinning when I try to unscrew the axial ball.

Just bought 2 new axial ball joints for my bx2200. I am having trouble unscrewing them from the hydraulic steering shaft as the shaft is rotating when I try to unscrew them. Is there a trick?

Has anyone else had the left side of the mmm come loose from the spring loaded pin? Mine did 2 times today...simple fix...pull the pin outwards, lift the deck by hand...reinsert pin into deck bracket...

My father has an International 234 tractor with "K3B 30318" on the engine valve cover. That being said, I am trying to determine what glow plugs this engine uses. The Mitsu part doc that I have state that the K3B engine is used for one of the following models: K3B 61A For Industrial Use (STD...

I recently purchased a Kubota BX2200 with LA112 Front Loader and 60" MMM for $7500. The tractor has slightly over 400 hours and I just changed the air filter, front axle fluid and hydrostatic fluid/filter. I removed and cleaned the strainer during the hydro change. I also greased the loader...