Search results

This project took my rear 540 pto 3 ph mounted snow blower and mounted it in place of the 72" pin on loader bucket. The tractor is a L4610 Kubota & LA852 Loader. It uses a hydro-pac pto driven 20 gpm relief protected hydraulic pump and 3/4" in. HP & LP lines to the proper sized blower...

Swapping over from Winter/ Snow Thrower to the Mower Deck 3461 I find it impossible to connect the "Traction Springs"? I've gone through multiple cycles of "power fold" and "deck height" change including "adjusting (loosening) the traction springs" adjuster...... no luck. I can get at...

I am now beginning the 3 rd winter after moving the PTO 3PH snow blower to hydraulic drive mounted 4 PH on the LA-852 Loader. Just a couple days ago we got 16" of snow over night. Blowing Snow going forward is clearly more fun! My "Mule" is a 14 year old Glide Shift Kubota L4610 with a...

My Kubota L4610 has just shy of 400 watt block heater which I've used exclusively on an old 24 hour clock timer. I only hook up the switched power from it the night before to enable heat power on at 5 or 6 am. 3 or 4 hours later I show up at the machine shed...................... you get the...

I'm about 95% completed on my Front Loader Mount Snow Blower and Rear Hydraulic Tank PTO driven ... project. The ambient temperatures I've operated in since early December is about 20*F. So far with a reduced amount of UTF oil (15 gals) even after an hour of snow blowing at approximately 500...

L4610 GST shows 2700 rpm for 540 on rear PTO (Operators Manual) but my Engine Tach shows 2500? My (O. M.) has it printed 2700 rpm in more than one place. Ex. p42, quote ... "there is a PTO -1 540 rpm indicated mark on the tachometer board..." Hummmm? My tractor is a 2001 V2203-EHA...

Any metric sized hydraulic hose installed on the LA211 loader? Or, are they NPT and/or JIC 37 fittings ? Carl

My summer work is continuing on my "3 ph blower move to front loader sans bucket". My pin-on blower frame is done and it fits the blower (3 ph OEM frame removed). And the tractor 852 loader fits and easily takes the 1 & 3/16" (4) pins. The Surpluscenter.com hydraulic motor 9-7080-160 is...

Acetylene is closing in on a 100 dollars a fill........................... My gauges/ torch setup is Harris EP* so converting to Propane is not advised. A new 220v Plasma Cutter costs something over a 1000 dollars but how is it for heating... steel 1/4, 5/16, 3/8" plate? Jobs? Fixing...

I plan to move my 3 ph 66" snow blower. It will be on the same Kubota L4610 & La 852 loader (but sans 72" bucket). The new loader mounted snow blower mt. frame is nearly done. Next will be cutting, welding up the mounting "ears" on the new blower frame. It will mean dropping off the 300#...

Reading where Stick Inverter welders are powering an air cooled TIG torch showing some very good welds....................... Has anyone tried the likes of a Miller Thunderbolt 220 AC/DC that uses a heavy transformer with a top mounted crank handle to vary the shunt for continuous amp control...